Deena Mccoy Table November 03rd, 2018 - 07:05:57
That's the 20 and a half inch piece and the 14-inch pieces. The 29-inch pieces also need a hole, drill, nine and a half inches from the opposite in, okay, I have all my holes drilled. Now, I'm just gonna go ahead and mark and round over all the corners on it. If so, these two pieces here, I'm gonna round over all four corners on it and then on the top. Just the two outside pieces - I'm just gonna round over two corners on like that mark it out, and I found a cap that fits perfectly black metal water works out great.
So I'm just gonna mark those and I'll probably just take the little drum sander there and knock these off. It'S pretty soft wood, cut four little pieces there inch and a half long they're a little bit longer, but I'm going to use that flush side to trim them off afterward. So we need to glue one side of these in there they're loose on the other side, so just put a little bit of glue on there and one of these I need to cut two more, but they need to be a little bit longer. It supports in here and just picks whatever side you like best.
I would let the glue dry completely doesn't get glued together. I'm gonna start assembling the top of it here, so you need to find Center they're, 14 inches. So 7 inches you need to drill down in there, maybe a quarter of an inch. It does take a little dowel just a little bit. It sticks up the almost flush with the top to drill down in their quarter of an inch and leave that adopted a sticking out all right. So I found Center, so I'm gonna take it back over it drill, press and just drill down it.
I screwed up, I glued them into here, and I had to pull them right back out, so they get glued into. This is where the handle goes. So this was a long two inch pieces. They go into the outside legs, so if you don't have plans or one to look at it's a little little bit confusing putting it together so I'll show you real quick